Recent content by Outatime

Sorry I meant to reply to this thread, I did get a test done via ponoko at the start of the year for my Turtles PCB and it cost about $85 plus shipping, I used 4.5mm acrylic and went with the reverse so the design was on the inside as I was worried I would scratch it. I would like to do one...

Thank you , does anyone know if the OP is still here, I sent him a message , I found an online company that will do 2 for around the same price as above but I dont know how to edit the files, I don't need two sunset riders cases but if I can edit the sunset riders part out of the file I can use...

I just attached the quote I got from ponoko for $178 shipped, does that quote look right to you?

New member here, I just wondered if anyone state side found a online company to cut these , I found one place but it was like $180 for one which seemed like a lot of money?