Recent content by Paladin

To make a long story short, one of the 3 Naomi's I tested the JVS Bridge with doesn't recognize it but the other 2 do. The coin meter spoofing is also a non issue as Sikigama No Shiro 2 loads and runs fine right out of the box. The guys from Tucson Logic have great customer service even though...

I received a reply email. They flash the firmware and test on a Naomi before shipping them. They suspect it may have been damaged in shipping. There didn't appear to be any physical damage to the box or PCB but who knows. I went ahead and flashed the firmware just to see if it would fix...

Jumping in here to say I just bought a JVS Bridge for a project to mount a Naomi into a PC case with all the additional required hardware and this board sounded like a perfect alternative to the large Sega I/O. I have encountered a couple issues and have emailed the address noted on the...

I am using a single quote as an apostrophe in my wifi password. Thanks for the tip, I'll work on that this week. Update - success! Here are the steps I took to get the Adafruit 16x2 blue LCD (navigation buttons on right side) working with the Raspberry Pi 3 B+ using the AIO image, in case it...

I'm trying to get mine on my home wifi so I can SSH in to try and get my LCD working. On the setup screen I enter my non broadcast SSID and password but it's not connecting. I notice that the top field that picks up broadcast SSID's auto selects one with no way to deselect it. I'm wondering...

I assembled my Adafruit 16x2 blue LCD (navigation buttons on right side) today but all I get is a brief backlight flash when booting wipi. This is on a Pi3 B+ board running the new AIO image. The wifi and UI is working fine, although I haven't connected it to a net dimm yet to finish testing...

NOTE: I just bought a PNY 32gb class 10 micro SD card and the AIO image won't fit. Etcher shows my card as being 30gb. I also tried Win32diskimager with the same results. Is there a way I could edit the image to remove some games, say Naomi 2 Triforce and Chihiro, so that the image would fit...

rtw, I don't think HOTD2 will ever work on a Naomi2. From the reading I've done, HOTD2 only runs on the Naomi 1 motherboards from the first generation. From segaretro.org: "After The House of the Dead 2, a newer revision of the PowerVR2 graphics chip was used in subsequent NAOMI systems". The...

I PM'd you. I'm located near Seattle in the US. I have 3 boards that need the sound fix and firmware update for auto reboot.

I sent a PM a few days ago about sending in 3 kits, but haven't received a reply with where to send them. I've been having some issues with my home email, so I wasn't sure if the reply got lost or you haven't had a chance to get back to me yet. I'm not in a hurry, just trying to make sure I...

Finally got around to signing up here. Just in case anymore data is needed for this issue: I bought 2 kits and they both have the crackling sound issue. One is running on a rev 7 board with no jumpers, the other is on a rev 4 with jumper wire from PAL to kit because running it under the board...