Recent content by phoenix07

It seems it was too late, I saw the corrosion through the other side ||

I thought my supergun is not designed good enough for power delivery as you said but for other boards it working properly. After I connected to ATX-24 pin via ATX breaker board and I got 4.84V at JAMMA edge I thought it should enough to operate the CPS2 but I got another issue instead X/

Thanks for your information :) I've connected to ATX-24 pin via ATX breaker board and I measure 4.84V at JAMMA edage, I got video signal but it's a red screen I checked the board and I found that the battery is already dead :(

I think "sense lines" is what I'm looking for but how can I identify them because there is no mention in the PSU's specs. ===================================================================================================== I found below information from this site >>...

I've ordered the ATX breakout board and I will connect supergun via ATX 24-pin instead of Molex 4-pin

I connected my supergun using the wire with Molex 4-pin connector (included in the box) and it seems too long. I can't connect with the 24-pin ATX due to my supergun doesn't support it. I will try to make a shorter wire for Molex 4-pin but I don't know what is a type of PSU's connector

I've tested with CPS2 board and I saw that the 5V was dropped to 4.62V and there is no video signal :( I also tested with MVS and System-11 boards I got 4.91 and 4.89 respectively but they are working properly. Any suggestion?

I got it today and will test tomorrow :)

Thanks for all comments, I will replace the old one with the COOLER MASTER MasterWatt 650W :)

Hi, I've some questions The Cooler Master MasterWatt 650W you've picked up is a 80+ Bronze or 80+ Gold? Is it working properly with most arcade boards? I've tried to use ATX PSU (PC) for arcade board such as CPS2 but it doesn't work due to the voltage was dropped below 5V and there is no...