Recent content by raidenmaniac1

Wish I had the money... Free bump.

did you check the 5V pin on the JAMMA connector with the PCB connected and powered up ? you should read 5V. below it that may cause you PCB to act up.

Only 10M ? You must try harder! just kidding. welcome :)

Can you install FreeMcBoot or FreePSXboot on this memory card too?

please add me for 2 one for me and one for myself

does it run encrypted ROMs w/ key writing ?

Which version on Viper Phase 1?

I m getting a serious hard on

that 's some sexy Cave PCB underwear right there

mine has the PCB serial number engraved into it.

when will we get another run pleaaasssseee?

did you try to "reseat" the B board into the A board ? I see this jail break patterns when the pins are making not good contact.

I didn't know of the Din13 to DB15 adapter; That's good to know. I made Din13 adapters for my LS30 rotary and Arkanoid spinner controllers instead.

So much hoarding! So little place! you are going to have to make a choice

Take a look at Sigma Superguns. There are several versions; all in one "Raijin" (Joystick panel + JAMMA interface + AVout) and my Favorite AV7000 (JAMMA + AVout) w/ separate 9000TB controller. The cable linking AV7000 to 9000TB is Din13. Later on, you can build custom controllers once you...