Recent content by Scarletspeedstr

Would definitely grab a multi and a Dash set as well. I’ve been checking the site the past few weeks hoping for a restock too.

Pending payment.

Original card from distributor. I’ve played with it a bit and it works as intended. No SD card or pirated software included, please don’t ask. PayPal F&F $65 shipped in the US.

Not at this time, no.

You can kind of see it on his website. The far left and right are ground. The middle pins are the buttons. Easy to make or modify your own harnesses.

It comes with this, which is fine for a lot of small to midsize boards that aren’t power hungry. Honestly, I’d recommend grabbing one of his Pro PSUs so you have plenty of juice and can adjust the voltage as needed.

Thanks for the offer, but I have a Blast City.

Taito Vewlix Diamond Orange arcade machine. The cabinet itself is very clean, no smoke smell. Upgraded 1440p monitor with Hadouken brackets. Original Taito 1080p monitor and bracket is also included in the sale should the owner wish to revert to stock. The cabinet is running a Taito Type X3...

I can only recall seeing that cart in clear blue like you mentioned. Be careful with the contact cement, it can sometimes leave what looks like a grease stain if the paper absorbs too much. I’ve had better success using 3M double sided tape, taking my time, and cutting nicely sized pieces of...

It’s often difficult to walk the line of keeping something like this watchable for everyone. I know it’s pretty elementary for this crowd but I always hope I can pique the interest of a few mainstreamers and show people there’s a whole other world out there beyond Zelda.

Can confirm that a second Apacer 4GB DOM I tried DOES work. So I have one that does and one that doesn’t. Both work in Windows and I wrote each of them with CHDMan. I can also confirm that swapping the battery on the board fixes the max volume setting at boot. That’s been a really annoying...

I may have been able to reuse what was there, it’s been a while and I can’t recall. Either way, the tubes always come with small holders you can mount if necessary. Wiring is pretty straightforward. There are two white wires, one ties to hot (black) and the other neutral (white). For the...

Yes, that looks like the same adapter. I’m using 4GB cards (Transcend and Verbatim), not sure I have anything on hand that’s smaller.

That probably explains why the plastic connector is broken on my board. But no, I knew the correct orientation from the ribbon cable that was attached when I got it. Good thought though.

I sure have. It’s bizarre. I’ve always assumed these were just pass throughs.