Recent content by SnakeGrunger

I would declare interest in 6, I can edit my post in a little bit once I get home, but that would be my baseline I'm 95% sure.

Hi everyone, A friend of mine had a Windy2 without a fan shroud, which seems to be rare, and I 3D modelled one and had it made. Here is a video showing fit : View: https://youtube.com/shorts/Wy8kxxu3lRk We would have 5 made, but if we can get to 10 it would help bring cost down. This is...

@ImportantBet yes these are Hammer casters, they probably made all the wheels that shipped with most candies out there !

@Ziggy Cheetos Dust 56×28 mm are the dimensions for the mounting holes on these. I think Aero are not exactly the same but I could be mistaken.

More sold, only 2 sets of phenol types left, price lowered.

5 more available for sale! Although I do not have anymore of the RGB LEDs in stock and will not include. Ken over at irepairsega.com can offer full assembly service if you send him all the parts needed for a 400$ flat rate.

Two sets sold - 2 Nylon sets and 3 Phenol sets left.

Don't drop the unit ! That kind of impact can break the BGA soldering.

@leonk I did pull mine from my original Genesis. According to the datasheet, you will need the following : 14x 2200pF https://mou.sr/41Tkpgz 2x 270pF https://mou.sr/3js9red Also someone pointed out all the components are stuffed, however if you have a VA0 or VA1 32X, PAL or NTSC revision you...

Bumping old thread - have 7 more units for sale. Board is the same, but mounting plate will be cut acrylic with spacers. I have some Sega JVS IOs I can sell as well, 35$ extra.

Naomi2's notorious for failing unfortunately. Ken used to reball BGAs, but said he quit doing it because it was so time consuming. Sega's board designs meant you had to redo all 3 BGA chips for every service, as the chips were too close to each other when heating up the board. Biggest culprit...

Price reduced.

@leonk I used them as I had bought them a while ago and on standby.. those are very low ESR. But I'm sure regular electrolythic caps will work fine. @mathewbeall good question - I swapped all the capacitor and resistor values for NTSC signals, see attached image. In the build C15 and C576 are...

Here is my finished build.

As the title suggests ! One set of two swivel, and two straight casters OEM supplier, I have 0 (sold out) set of white Nylon type (like original Taito) left and 2 sets of Phenol type (rubbery). Price is 35$USD for a complete set of 4 casters plus shipping (like 8-10$) within US, EU about 28$...