Recent content by Stac2000

@psykom thanks. I wish I had asked about this sooner. I got spoiled with the cps2 and stv setups which are basically plug and play in comparison to the F3. I really want to use this multi before selling. Very frustrating for a noob like me.

Long story short. I pulled out all my multis this weekend to test before I list for sale and my ossc now shows “init error -2”. Was just trying to get the F3 tested with the vga hat I just purchased . 2+ years and no luck playing it. I tested with my gbs8200 when I got it. No issues...

Welcome fellow New Yorker! This forum has been extremely helpful and a great resource - especially for beginners like us.

I need one. Pm sent

Definitely in for one. However, can someone clue me in as to exactly what hardware is needed? I am doing my research but I am not familiar at all with the CPS1 hardware. Even as a noob, the other DS multi's I purchased (CPS2/F3/STV - soon to be MVS) seemed very straightforward once I looked...

definitely interested in a second version with a solid top

Thanks. I sent a PM to Mitsu. I am dying to play this thing. Frustrating - I actually bought the multi a year ago from Paradise Arcade and it has been in the box the whole time. At least I have the F3 and STV to keep me satisfied for now.

I just fixed the broken pin by installing a new one I recently received from Mitsu. This was easy enough to do.However, I am having bars/blocks in the image which seem to be worse than before I fixed the pin. Board seems well seated and will not go any farther. I have attached some pics from...

Some additional info: By graphics issues I mean mostly bars similar to recent posts. I just recently installed the kit. I did have a sound issue that I resolved by fixing the jumpers. At least two looked open but were actually shorted so I made cuts and saw a big improvement there. Then I...

I am having the very same issue with the graphics, except I do have a broken pin, please see attached pic. Notice one of the pins in the middle of the pic is broken. Suggestions?

I tried again removing the sync jumper for TTL but still no change. Thanks to all for your help on this.

Ok, thanks. I will contact Retro Access, it seems like they have a good return policy.

I recently purchased the cable shown above from Retro Access, however I cannot get any image, the OSSC just shows No Sync. Has anyone else had any luck using this cable with the latest version of the HAS? Did I buy the wrong cable or a setting on the HAS? I also purchased the self solder adapter...

MV-1FZ Hopefully can get something for the 161 in 1 otherwise an overpriced paperweight.

Missed out last time around. PM sent.