Recent content by travisaur

Had an Astro City where the 12v line cut out - could still boot boards off the 5v but the 12v carries the sound. Took readings off of voltage regulator IC2, ~13v going in, 0 going out. Where things got tricky was when looking an applicable datasheet for part 3122v (the one I removed had pins...

Wanted to thank you for sharing this! I also got running on Taki Udon’s board after a few hours of troubleshooting. I was following all the config tips in this thread and for the life of me could not get the controllers to work, even on a new install of fusion. Thanks to going over your setup I...

Wanted to shoot an update on this machine – project ended up on the backburner but moved back up this summer here! Couple of hopefully good leads – first of all acquired some stock of UPC-2010 cartridges that although not exact what the YP-2301PT printer uses, it’s enough to at least get the...

DMed!

DMed!

Updated kits tried with three different failures. Waiting on mitsubishi CP710 to arrive as it looks like I'll have better luck procuring for that printer.

I think this machine may have an undumped version of the Print Club "California Ver". Looking at dumped roms I haven't seen this one on any sites or able to see any mentions on searches. The front of my machine has a damaged sticker with some of the frames in view and I attached the image of the...

(Cross posting my post from KLOV- mainly because I see a lot more posts about print club stuff over here!) Backstory: Was out at CORGS-CON in Columbus last weekend, me and friends had brought out a 16 foot truck full of games for people to play (various consoles, a full 10 station Steel...

Know theres a decent chance it's gone by now, but if you have any print club stock left I'd definitely be interested! Hope sales went/ go well otherwise! =]

Yeah, once construction is done in my basement (currently getting a french drain put in) I'll be putting my machines back in place and tweaked up again. For tonight, back in plastic wrap the machine goes! Cheers again everybody!

After getting a new cable from highscoresaves and mounting everything back down I am well up and running! Cheers again to the lot of you to help the troubleshooting process, you all rock!

Success! One corner was a little loose that I didn't get when pushing down the sides. At least it is working with the decrypted files now! Now to just figure out the encrypted files. Hopefully it's just the key cable now. Again, very grateful for the lot of you!

PROGRESS! Did another round of disconnecting A/B board, discharging EXC5, and reloading the larger 32gb sd with the decrypted 2020 roll up pack I got off of archive.org . Much better results than I have been! Going to try the 2GB I have next with a couple of the games and see...

It was from highscoresaves- added to the same purchase when I bought the 2020 darksoft kit The wires look a little criss-crossed but it does look like pin 2 is connected to 2, 3 connected to 3, 4 connected to 4, and 5 to 5. Looking at that other reference image, should the pins be going...

Powered off and unplugged board, separated A and B board, shorted EXC5 on bottom of B board (middle to right, middle to left, and across all three) for 60 seconds a piece Same result. Thanks for the assistance, appreciate you all!