Mine wasn’t bad enough to warrant this - but I had an idea to 3D print a “cap” that covered all three sides of the corner - and have it look like a sort of bumper to protect it from further damage.
@purbeast have you been following the development of the Arcooda 4:3 LCD arcade monitors? They’ve had some setbacks with supply chain and tariff challenges but it’s the best chance arcade collectors have at replacing CRTs...
I’ve got the machine inside now out of the winter cold garage. I took a quick pic here but have had to move it into a bedroom because there’s no room left 😓
I previously had permission from my wife to block the lounge room door - as below, but not any more. I tried it on but it didn’t fly this...
Okay good stuff. I used that vinyl dye paint and it was called “white” but is slightly off-white which I reckon is correct. It’s not as off-white as the back panel though. When you take off the Namco badge you’ll what I reckon is close to the original colour. I would have used a hair dryer to...
I’ve had success in chocking up the back of the machine on something so it’s leaning quite far forward. My other half won’t help me lift the machine out but she can tilt the machine for me. That way it’s easier to bring forward to your body.
Lifting over a control panel just sucks - so if you...