What's new
By:
Filters

Pgm Volume pot Replacement

Morzana

Morzana

Beginner
Joined
Apr 11, 2016
Messages
30
Reaction score
10
Location
France
Anyone found a good equivalent gear volume pot for Pgm slot ?
 
1k P104 pot works fine. you can ghetto style it, extend the wires or do it more proper.

Previous owner of mine thrashed it pretty bad.

67875915_10114266804002335_2505686445927170048_n.jpg

68735247_10114265027602255_3282102067870564352_n.jpg
 

Attachments

  • 68484351_10114265027946565_2645673706575101952_n.jpg
    68484351_10114265027946565_2645673706575101952_n.jpg
    39.8 KB · Views: 196
Finally got my minigun supergun up and running. My IGS PGM isn't outputting sound though even after a recap. I am guessing it's this wheel? Is this a normal problem on the PGM's ?
 
Still not getting sound out of my igs. I tested a volume pot that was linked above by GCtech but to no avail.

I tried looking in the bios settings and music and sound is set to YES or on. The Minigun supergun I'm using works with my other arcade hardware.

Any help?
 
I found these radial dial pots as a close replacement. They aren't 100% pin compatible - you have to solder a wire link underneath, but they work well:

1612405504910.png


If you're not getting any audio try shorting the pins with a wet finger around that pot area. If you don't get anything, not even a hum then your audio amp or 12v in is bad.
 
You must log in or register to reply here.
Back
Top