Search results for query: *

Looks like a repro pcb, so most probably not an original rom board.

My readings, Gundam Stick, no Op Amp, no resistors but with a 3D printed restrictor based on nems measurements. Feels good. Played a lot on a friends original and dont feel any difference. Plays great with this setup. Managed a flawless clear which gives you the 3 extra stages on normal for the...

M4, 6mm Button Head

Working on a new banana. Looks nicer than the old one. New banana on the left. Printed in one piece.

Controls will not work through the supergun and Saturn uses a decoder fir the signals as far as I remember, so you would have to directly wire the 2 pots in the controller to the G-Net PCB.

I can print one for you if you want.

This is a common problem on m92. Fortunately an easy fix!

Also a C64 & Amiga kid. Welcome!

Still using Fusion 360 and loving it.

I use the bambu stuff. When you order 6 rolls you get a big discount and once you have a few spools, you can get the refills which are even cheaper.

On the JST 1 - 12V 2 - From Output pin on IO via custom Amp 18 3 - To IO via regular Amp 12 4 - GND

Yes, I can make some mire pics later.

Yes, that is what I did. Also took the 12V from there.

more around the fitment of the nuts and the dept of the screw holes. Depending on the filament, the sides can sag a little which leads to those gaps. Depends a bit on the printer too.

@GC8TECH had different tolerances on his printer, so we had to adapt it a little for him.

add me to the list too!

What a journey! Great write up and fix 👍🏻

very nice, cool colour!

here you go!