Search results

Add me to the list, please. 1 for MVS.

Yeah, my setup is very sensitive as well. And it's not selector based. When it messes up, it messes with and without selector similar way. And when that happens, some games tend to still work just fine, but half or more will not.

PM'ed itman312 last night... And for others seeking for the same: yeah, I have the selectors in stock. C2, S16B and M72 selectors available as well.

Up! A few in stock and can build more.

Maybe... depends from total price. Add me to the list, please.

If interested in LCD multi-selector. Send me PM.

If you want to buy LCD-selector, just send a message...

That shows well. Thanks. Hmm... No +5V on that header though. Anyway, for clearance (for others reading the messages): the picture shown above in BladeZX post is for S18, NOT for M72 PCB/Multi as this topic is/should be. We are wandering fast off-topic here :) I believe we should end...

Chrome in use here as well. Odd... I'll try FF later.

Sorry, that image doesn't show at all. There are also other problems around the forum with pics, only small pics may show, but when clicked to bigger -> "The requested content cannot be loaded. Please try again later." If I try to open your picture link directly, I get: "Oops! We ran into some...

Current installation instructions for the LCD-selector: http://kameli.net/~stt/LCD_M72_multi.pdf

Yes, +5V. And you have to connect wire directly to CPU-leg or to solder point (socket) under the leg. Those are the easiest places. There is a chip nearby which drives this line, but less surface to solder there. None through-holes between the chip and CPU socket/leg on that line. S18 I know...

I didn't take a better look, but note that reset is opposite with M72 than for ST-V, S16B, C2. I recently asked about details from S18 multi in another topic (for modifying the LCD for it, because of one request I got), but so far the questions ignored.

There is some, I have already modified the LCD-selector (ST-V, S16B, C2, M72) for M72 use and sold a few selectors. Request for them is/has been a lot lower than for example ST-V or S16B.

Another member of this forum asked if I could modify the LCD selector for S18 use, so: 0101 -table for each game? 4-pin connector pinout? Reset is GND or +5V based?

Send a PM, please.

Hmm... I don't have S18 multi/PCB myself, but if the selection logic is similar to for example S16B, it should be trivial modification. Send me PM, please.

It's 1:1 match to the DIPs.

Those are basically only "data"-lines. You can compare the function with the dip switches next to that connector. Game changing via dip-switches (without selector at all) works fine? When you're trying to use the selector, are all dips set to 0-position? Ok, I have no experience from the...

Copied from another post, CN5 pinout: Red +5V Black GND White Reset Which kind of selector are you trying to install, LCD (by me), Oled, something other?