Search results

Welcome, glad to see you here!

Let me dig them out :)

C-Roms are for GFX tiles, so that would account for graphic issues. Does the problem change when running the board without that mask rom?

you are using the component input on the gbs. I think you should use the CGA/EGA input on the left of the VGA input connector where you can feed RGB and sync.

Sure, I cut them on my Silhouette. The design itself is in Corel Draw. So I have that plus the exported image itself. Can also print/cut a bunch and send out.

Finished the work on the S18 Multi enclosure. Thanks to VJP for lending me his multi! Can be found here: https://www.printables.com/model/847985-sega-system-18-multi-case

Very nice design! Do you have spares of these or are the gerbers available somewhere?

Thank you for checking. The adjustments were for an original short rom board. It is pure luck that the multi fits at all. Once I get the multi I will make a dedicated design for it with proper cutouts for the selector. Also agree, the shell will be even shorter.

Printables page is updated with the 2 new SLTs for the small case.

Thinking about it, I could make the case for the short board shorter. This way it will fit on smaller print beds. Same for the case for the multi.

I should get the multi from a friend on Saturday to adapt the enclosure, so there will be an update for that soon. I was thinking about a knob that goes on the selector. This way you could put a label on the case with the game names based on the position of the knob. My printer is an Bambu Lab...

My Prusa MK3S+ was acting up. Even after replacing all the bearings, plastics and hotend it is still a mess. Ordered an X1C with AMS a few weeks ago. Has been running almost 24/7. Had a bit of a struggle with PETG but then found a profile online that works great. Super happy with the results and...

I had a few Sega System 18 rom boards that I wanted to better protect. Came up with a case design that fits both the short and long rom boards. Let me know if I can improve the design. You can get the files here: https://www.printables.com/model/836536-sega-system-18-rom-board-case

No, the LS-30 work completely different from a spinner.

As far as I remember there was an option in the config file of the game to do so for some of them.

As far as I remember, sengeki only works on asia/jap regular bios with the respective eproms.

by local I mean in your country :) this is a global community.

You just need an eprom reprogrammed on the senkyu cart. I am sure there is somebody local to you that can programm that eprom for you.

Very nice. Am also thinking about getting an X1C. Any recommendations for PLA/PETG filaments that work fine with the X1C?

Read somehwere that you can switch the Super Nova Motherboard into Spinner / Knob mode. After some digging and trial and error I managed to get it working. To enable Knob mode you have to put DIP 1 to on which will put the board into test mode on startup. There go to the System Configuration...