mv1c

I found an original Japanese version MV1C cartridge slot that’s different from the regular ones. It has sharp right-angle corners, with tiny stamped serial numbers and larger "JAMMA" letters printed on the reverse side. The fuse holder is distinct, the adjacent solder pads are bigger, and all...

I have an mv1c that used to drain a full battery In about 30 minutes. I installed a ml2032 and universe bios to no effect. Removing capacitors c3, pc2 and pc4 from the board slowed the drain to about 24 hours. This is not a major issue and I understand that this can happen to the mv1b and mv1c...

Hey folks! I'm hoping one or more of you out there might be familiar with the NeoBiosMasta mod; or, more broadly, unibios installation on an MV-1C board. I'm attempting to give it a go here, and I'm afraid I've run into a bit of a wall. I'll start at the beginning: I utilized a heat gun to...

Sell some of my collection of more than 4 years of goods, need the game can leave a message or send information, it is best to buy more at a time, otherwise the freight is not cost-effective, China delivery, there are a lot of labels rotten or incomplete I have changed the color label, the game...

Anyone has seen it before? Where is this "NEW CHANNEL" SNK manufactured off? I know MV1-FZ models were also manufactured by Neo-Geo do Brasil but didn't know about this specific MV1C model. Bootlegs of MV1C boards does exist but this one looks too good compared with the bootleg version...

Until recently my MV1B still had the original rechargeable battery. It looked a bit grotty but hadn't leaked however it wouldn't keep a charge for very long so I figured I should replace it pronto. I bought a Dreamcast battery kit as it looked like the correct lead layout but it was only when I...

Hey everyone, Looks like I somehow ended up with the MV1C from hell. Had this thing for years, and it only recently began exhibiting problems: Random resets. To be clear, the random resets were happening before I attempted the recap. This seems to happen more frequently when using flash carts...

Looking for a working, clean MV-1C board in the US. Also may be interested in lower priced MVS carts and multi-carts.

I decided to spice up my neglected little one slot MV-1C with some long over due work while I watched a movie. I decided to re-do my old full recap job since it was one of my first attempts, long before I had nice soldering and desoldering stations and quality caps. I also cleaned up my old...