WTB 3D Printed PSU Mount

[Dreygor]

Looking for someone who can affordably 3D Print a couple of these PSU mounting brackets. Any material as long as it will do what it needs. What is the estimated cost on each?

Thanks!

http://www.thingiverse.com/thing:867934

 

[ekorz]

Well if @twistedsymphony is out, I had luck using 3D Hubs

 

[twistedsymphony]

It'd be about $22 per for me to print something that big. that thing seems way oversized, and not in any way that improves it's robustness. I'm not even sure I could print something that wide and flat without warping issues, at least not until I upgrade the bed on my printer.

 

[Dreygor]

How much do you charge for altering the design? You could do it all as frames (no solid filled in surfaces) and it would be fine for me. I just want something to hold the ATX PSU in place in that same position.

 

[twistedsymphony]

I prefer not to alter designs. This one doesn't have the solid model available anyway.

 

[twistedsymphony]

so I just threw together this design:

These I can make for about $5 a piece.

 

[Dreygor]

so I just threw together this design:

These I can make for about $5 a piece.

PM sent. That seems really efficient and space saving. To minimize the vibration I will mount that and the PSU on a thin rubber mat.

 

[dnphamus13]

Don't know how you are going to use it, but I had these printed for my application......just gotta find some long zip ties

http://www.thingiverse.com/thing:860327