- Thread starter cruzlink2
- Start date
kazuo
Grand Master
There's a thread for these questions here! There's a spreadsheet linked from Franco that might have some info.
Also... it looks like it might be JST EH, kind of like the Toshiba boards?
Hope this helps!
Also... it looks like it might be JST EH, kind of like the Toshiba boards?
Hope this helps!
cruzlink2
Professional
thx but these one are not female to male connectors seems like the entire connector is crimped and soldered to the board.
Ziggy Cheetos Dust
Grand Master
Maybe a JST EHR-5.
that fits into a B5B-EH which is mounted through the board?
https://www.digikey.com.au/en/products/detail/jst-sales-america-inc/EHR-5/527227
that fits into a B5B-EH which is mounted through the board?
https://www.digikey.com.au/en/products/detail/jst-sales-america-inc/EHR-5/527227
Last edited:
cruzlink2
Professional
Ziggy Cheetos Dust
Grand Master
I’ll follow how you go @cruzlink2. I’m looking to put a 2931 into my Windy II.
I bought one of these as a starting point.
https://www.ebay.com.au/itm/1742203...apEstSXRAm&var=&widget_ver=artemis&media=COPY
I bought one of these as a starting point.
https://www.ebay.com.au/itm/1742203...apEstSXRAm&var=&widget_ver=artemis&media=COPY
Ziggy Cheetos Dust
Grand Master
@cruzlink2 ok had a look at my 2931 and I see what you mean. The connectors are fixed to the board. So yeah, I don’t think what I wrote above is correct. Those ones are for the video signals I believe.
Ziggy Cheetos Dust
Grand Master
Looking at my 2931 I was just thinking about a good old cut, insert new length pieces, solder and shrink wrap. I’m very reluctant but sick of looking at an otherwise perfectly good cabinet not running. I also wondered if I could just raise the chassis up higher in the windy ii to avoid lengthening these neckboard wires.
