Spixel
Beginner
Hi,
New to the board. I've recently acquired an older box that has a 38 in 1 Jamma board in it. I'm in the process of fixing the original Well Gardner 4900 but wanted a back up just in case. I read that getting a Dell 2007 FP is the best option since it's actually 4:3. I've set up the monitor and there's black bars at the top and bottom. This doesn't seem to be a monitor thing but from the board, if I make it 1:1 you can still see the black bars in a lighter black above the test screen. I've reset the monitor many times and nothing seems to fix it. Any insight would be greatly appreciated, I've researched and have hit a bit of a dead end. The only defining feature on my Jamma board is "HPH ver 309" and a serial no. 290231 I've attached a photo. Thanks, Shane
New to the board. I've recently acquired an older box that has a 38 in 1 Jamma board in it. I'm in the process of fixing the original Well Gardner 4900 but wanted a back up just in case. I read that getting a Dell 2007 FP is the best option since it's actually 4:3. I've set up the monitor and there's black bars at the top and bottom. This doesn't seem to be a monitor thing but from the board, if I make it 1:1 you can still see the black bars in a lighter black above the test screen. I've reset the monitor many times and nothing seems to fix it. Any insight would be greatly appreciated, I've researched and have hit a bit of a dead end. The only defining feature on my Jamma board is "HPH ver 309" and a serial no. 290231 I've attached a photo. Thanks, Shane