What's new
By:

Chewlix and a Taito Type X2

S

Spunkworks

Beginner
Joined
Feb 5, 2017
Messages
34
Reaction score
11
Hi peeps,

Today I got a Chewlix L cab from a friend who wanted to free up some space in his man cave.
The cabinet is JAMMA wired, but I want to wire my Taito Type X2 hardware to this cabinet, but I have no clue what to get.
Do I need some JAMMA to JVS convertor, or is there some JVS wire harness I can buy to get this setup working? If possible i like to be able to switch between JAMMA and JVS.

Any help would be greatly appreciated.
 
HI Spunk,

It sounds like you need a JVS IO, have you had a look under the hood, there may be one already fitted and you will be good to go.
 
thegreathopper said:
HI Spunk,

It sounds like you need a JVS IO, have you had a look under the hood, there may be one already fitted and you will be good to go.
Click to expand...
Hmm, i don't think there is one installed, I just see a JAMMA connector. Would a SEGA IO from a Naomi cab work?
 
JoeAwesome said:
Yep. A Sega JAMMA to JVS IO would work. Just need a little bit of additional wiring to go with it.
Click to expand...
Yep, but i found a better solution, a Sega JVS IO with JAMMA edge.. Should basically be plug and play, i hope.
 
It’s the same thing. Pretty plug and play for anything less than 6 buttons. You’ll potentially need some extra wiring for the kicks (buttons 4-6)
 
JoeAwesome said:
It’s the same thing. Pretty plug and play for anything less than 6 buttons. You’ll potentially need some extra wiring for the kicks (buttons 4-6)
Click to expand...
I managed to get it working, button 1-5 over the jamma edge and button 6 to the IO's kick harness..
 
You must log in or register to reply here.
Back
Top