CPS2 18in1 multi

[YerpS3s]

Hello everyone i received this 18in1 multi that had various issues with sprites, resolved it by changing the A board, but part of it required moving over a cable from the old A board. I Snapped that cable after moving it from the old A board to the new one. I was getting illegal instruction whenever i change a game on the multi.
heres a video of the multi in action not my vid

View: https://www.youtube.com/watch?v=WCOiuq3nh50

 

[hatmoose]

Some nice cabs in that video, i've never actually seen one of these in action before - thank you for posting. There is not much discussion on the chinese 18 in 1's on arcadeprojects - they dont get a lot of love when the Darksoft CPS2 multi is so good and Darksoft has done so much for the commmunity.

I'm not sure if I've understood the problem - that looks like a fairly standard JST XH 5-pin shell to me. Should be reasonably easy to extract the broken pin from the shell , crimp a new pin on to the wire and re-insert? XH pins are a bit of a pain to crimp, some generic crimping tools claim to crimp them but in fact do not crimp them

 

[YerpS3s]

Some nice cabs in that video, i've never actually seen one of these in action before - thank you for posting. There is not much discussion on the chinese 18 in 1's on arcadeprojects - they dont get a lot of love when the Darksoft CPS2 multi is so good and Darksoft has done so much for the commmunity.

I'm not sure if I've understood the problem - that looks like a fairly standard JST XH 5-pin shell to me. Should be reasonably easy to extract the broken pin from the shell , crimp a new pin on to the wire and re-insert? XH pins are a bit of a pain to crimp, some generic crimping tools claim to crimp them but in fact do not crimp them

Yes i just needed the name of the shell, you think i can remake the wire? i purchased a darksoft mutli recently but have this one and wanted to make sure it goes toa good home after i get my darksoft