What's new

xlom

Student
Joined
Oct 25, 2018
Messages
74
Reaction score
21
Location
Texas
I saw some people fixed this by holding VOL down on boot or shorting the cap on CC18, however, I tried both of these (I held vol down until the region warning came up and I tried to short the pads on the underside of cc18 as the top part did not look like the pictures I found online. It looked like this https://imgur.com/a/Py1kRU7). I'm not sure what else to try. I know it's not my cab as switching the rca channels changes which speaker the audio comes out of.

Not sure what else to try. I saw someone mentioned his darksoft board B board would only do mono while a regular B board would do stereo in an old post. I only have my darksoft board so I'm not able to test another on it. Is there something on the kit that can cause that?
 

xlom

Student
Joined
Oct 25, 2018
Messages
74
Reaction score
21
Location
Texas
curious if anyone had other suggestions. I attempted to short that cap in my photo by touching the two solder joints on the underside of it, but it didn't seem to help with the audio balance at all. Not sure what else to try.
 
Top