Help restoring Sega Blast City

[vaughan14]

Hey, I've been restoring a gutted Blast City and I've managed to source/fabricate almost everything so far but I'm still missing two pieces.
If anyone has either HOT-1005 or HOT-1009 I'd appreciate it if you could scan them for me so I can CNC route some new ones, see photos for the exact parts.

Cheers Vaughan.

 

[vaughan14]

Bump, I'll paypal 10 USD each for a good scan of each one and the outer dimensions in mm.

 

[nem]

https://mega.nz/file/JuADQaRC#0XlKzEjE5CkXulXh-Bju9XK5N_j6_OhcQMvvypuvADM

199mm x 30mm

1009 isn't a flat piece, by the way. Unfortunately, I don't have them any more, otherwise I would have taken measurements for you.

 

[vaughan14]

Thanks so much, I'll trace this n post the file below .

PM incoming.

 

[vaughan14]

I don't have access to a laser cutter but ill CNC route it out of 2mm aluminium and just file the corners because the smallest bit is a 3mm.
I may paint in zinc paint just for authenticity but we will see.

Thanks again @nem

 

[vaughan14]

Fitment is perfect, I still need to get it some paint to finish it off and I have the correct female snap in connectors ordered.

I'm aware I work fast.

I still need to make a mount for the MS2931 remote board too.

 

[vaughan14]

Bit of a photo dump but I'm happy with the result.

Thanks to @nem and @Ziggy Cheetos Dust for their scans I wouldn't have been able to make these otherwise.