spartan1337
Student
I posted in a few groups / forums about a 29" Kortek 2901M with a wiggly yoke assembly as it had the adhesive cracked.
This turned out to not be an issue as everyone stated. A little hi-temp silicone and its solid.
The Monitor itself was not powering on at all and I got working again after I scoured forums and found threads with tons of info.
I found a few schematics. This one was useful and this one had a troubleshooting chart.
The chart had me replace IC601 and I reflowed the power supply side components. That all got me power.
Then I saw it had partial horizontal collapse.
I replaced and marked the caps around IC201, I think, for the vertical and that fixed that issue. Best to do them all but I just wanted to get it to good.
Some adjustment and it was back to working condition.
This turned out to not be an issue as everyone stated. A little hi-temp silicone and its solid.
The Monitor itself was not powering on at all and I got working again after I scoured forums and found threads with tons of info.
I found a few schematics. This one was useful and this one had a troubleshooting chart.
The chart had me replace IC601 and I reflowed the power supply side components. That all got me power.
Then I saw it had partial horizontal collapse.
I replaced and marked the caps around IC201, I think, for the vertical and that fixed that issue. Best to do them all but I just wanted to get it to good.
Some adjustment and it was back to working condition.