I have a C2 board that I've realised some of the player 1 inputs aren't working; namely the right direction and button 2. I've buzzed through from what I think are the correct fingers on the JAMMA edge to the pins on the 315-5296 I/O chip; both signals just pass through FLT34 or 38 and then both go through DA1, DA2 and RA4. Here's a diagram annotated with what I figured out:
Once I hit the I/O chip I was a bit stumped, and figured if that's the problem then I'm screwed. However on a hunch I tested the RA4 resistor array and the values are all over the place. Here's a closeup of RA4:
It's marked 102 so I'm assuming that's a 1KΩ array but I barely measure 650Ω on most of the resistors. Most importantly though, the two resistors I traced through I measure 12Ω and 90Ω (there's one other resistor in the array that measures 170Ω but I'm not sure what input that belongs to, nothing else appeared faulty on the input test in the service menu). The common pin on the array is tied to the +5V rail so I'm assuming this is being used for pullups.
Would this array being faulty be the likely cause of the two missing inputs? If someone could check my workings out, that would be appreciated!
Once I hit the I/O chip I was a bit stumped, and figured if that's the problem then I'm screwed. However on a hunch I tested the RA4 resistor array and the values are all over the place. Here's a closeup of RA4:
It's marked 102 so I'm assuming that's a 1KΩ array but I barely measure 650Ω on most of the resistors. Most importantly though, the two resistors I traced through I measure 12Ω and 90Ω (there's one other resistor in the array that measures 170Ω but I'm not sure what input that belongs to, nothing else appeared faulty on the input test in the service menu). The common pin on the array is tied to the +5V rail so I'm assuming this is being used for pullups.
Would this array being faulty be the likely cause of the two missing inputs? If someone could check my workings out, that would be appreciated!