I have this power supply installed in a Mini Cute and have it wired for JAMMA and JVS.do you have any picture about your installation?
The in-line fuse holders I have on the JVS harness have 7.5A fuses on the 3.3V and 5V lines and I haven’t had any issues. The PSU is rated for 10A on both of those lines. The only JVS board I have and have tested is NAOMI.is it sufficient for Naomo mobo or chihiro, 400 w required.
I have this power supply installed in a Mini Cute and have it wired for JAMMA and JVS.
The harness to the left goes to JAMMA boards and the harness to the right goes to my NAOMI.
I added an AMP connector to the JVS power harness so that I can easily disconnect a NAOMI board when not installed.
Here is the JVS power harness. I added in-line fuses as extra protection.
No cuttingreally curious how you wired up the additional outlets. Did you cut a hole in your mini cute?