The issue was solved thanks to help I figured out I had some bad cables, which is why I was having intermittent issues.
Hello
I have an NEC PG-2740 that has these issues. Sometimes it can turn on and be fine for an hour. Sometimes within a minute this starts. It seems to reset itself and loses the scan information and all geometry adjustments done since switched on so seems possibly power related. But also can look sync related when it fails to grab sync, so I am wondering where to start?
I know its internals are very similar to the XM29 so hoping someone has some experience or ideas where to troubleshoot - thanks for any advice
I have an NEC PG-2740 that has these issues. Sometimes it can turn on and be fine for an hour. Sometimes within a minute this starts. It seems to reset itself and loses the scan information and all geometry adjustments done since switched on so seems possibly power related. But also can look sync related when it fails to grab sync, so I am wondering where to start?
I know its internals are very similar to the XM29 so hoping someone has some experience or ideas where to troubleshoot - thanks for any advice
Last edited:
