Strider 2 Setup

[Fromhome]

Hello!

I'm new around here so I apologize in advanced if this is the wrong place to ask but I'm looking into purchasing a Strider 2 PCB and has a few questions.

My first question is would I need a special adapter to get the Strider 2 PCB to work with a HAS Supergun? From my understanding the Strider 2 board is a ZN-2 piece of hardware and HAS is meant to work with JAMMA. Would I need a special connector to interface between these two?

And lastly, are there any English Strider 2 boards? Or is it Japan only? Are there any mods to change the text language from Japanese to English?

Thank you in advanced!

 

[djsheep]

First question: No. it’s JAMMA
Second question. Yes. There’s an English version.

 

[Fromhome]

Thank you for your reply!

For the second question, do you know what region name I should look for? Also do you know if there are any English mods for Japan variants? Might have to explore that route since I haven’t seen too many English Stirder 2 boards

 

[djsheep]

Could be a simple ROM swap or more detailed. Maybe someone else can answer… ping for @Hammy

I just looked around and found boards from both regions. They’re out there. Good luck.