This issue has been happening for awhile. I'm not quite sure what's causing it.
I'll go to power on my NNC and the psu acts dead. if I unplug the Naomi and power the cab, the psu turns on and then I can plug in the Naomi and it fires right up. all the voltages are proper and steady.
This has happened with both my Naomi 1 and 2, and both with a netdimm and cartridge.
I tried going a little on the higher side for voltage and nada, didn't seem to help. I'm assuming there's an obvious answer that I'm not privy to, admittedly I'm not very good at troubleshooting with everything yet.
Any help would be appreciated
I'll go to power on my NNC and the psu acts dead. if I unplug the Naomi and power the cab, the psu turns on and then I can plug in the Naomi and it fires right up. all the voltages are proper and steady.
This has happened with both my Naomi 1 and 2, and both with a netdimm and cartridge.
I tried going a little on the higher side for voltage and nada, didn't seem to help. I'm assuming there's an obvious answer that I'm not privy to, admittedly I'm not very good at troubleshooting with everything yet.
Any help would be appreciated
Last edited: