What's new
By:

Wanted:forgotten worlds japanese control panel overlay

Has anyone managed to repro the metal topper on the Japanese spinners? The US/World spinners don't have the 3 "finger holes" :thumbup:
 
fuzzbuddy said:
Has anyone managed to repro the metal topper on the Japanese spinners? The US/World spinners don't have the 3 "finger holes" :thumbup:
Click to expand...
Me and a friend are doing this….
gTpNSMNh.jpg

ra9cQCxh.jpg

YfpJwmxh.jpg


In proto stage currently since i don't have the exact measurements of the japanise spinner, so this could not be 100% correct….
But the topper is just Amazing also this way….
Maybe it will be reduced a little since i think it's too big (5,8cm) and the holes need to be more deep (currently 2mm)
I think that 5,6cm of diameter and 4mm of hole deep should be ok and more similar to the real jap one.
It will be used on a modified Taito spinner….
We'll start doing this topper in some times, and some will be available if there is some interest about.
 
Derick2k said:
Looks amazing already. I would buy a couple if these go on sale.
Click to expand...
For sure they will be produced, in some quantities since me and my friend alone needs 4.
Minimum order i think it will be of 10 pieces, but that's not a problem for us.
I don't know the price yet, before we need to finish the design and have it really really similar to the real one.
Then we need to adapt it with the Taito spinner, but this is nearly completed too…..
 
I'd be interested in a set as well.
 
Thanks for replying back to me
It would be so awesome if it will work on
An original capcom spinner
 
I can measure the diameter of the hole and thread size.

Are planning on transforming a taito spinner into a push spinner ?
 
You must log in or register to reply here.
Back
Top