kind of a generic part but I built this for my Virtual On Twin Unit. The factory used a series of 4 post buss bars to split the low wire count output from the Peter Chou PSUs into the many wire count inputs on the Model 2 units.
Looking for Bus-bars online they wanted $20 a piece for what is essentially a piece of metal with some bolts through it. I noticed the 12V bars in the machine only had a few wires going to it since the Model 2 only uses it for the fans. so I build this binding post to replace the bus bar for the 12V wires and that freed up the larger bus-bar so I could add the 10 3.3V wires for the Model 3 boards that I'm installing.
More details on the hardware, print suggestions and assembly on the thingiverse page: http://www.thingiverse.com/thing:1523027
Looking for Bus-bars online they wanted $20 a piece for what is essentially a piece of metal with some bolts through it. I noticed the 12V bars in the machine only had a few wires going to it since the Model 2 only uses it for the fans. so I build this binding post to replace the bus bar for the 12V wires and that freed up the larger bus-bar so I could add the 10 3.3V wires for the Model 3 boards that I'm installing.
More details on the hardware, print suggestions and assembly on the thingiverse page: http://www.thingiverse.com/thing:1523027
