Karnov2017
Beginner
Hi everyone. Have an Elevator Action machine with a "game swap" modification on it so that the game can be switched to a different one via a button on the cab. Issue we have is the first slot came empty with the below 18pin connector wired as below. Trying to ID what board this connector might be so we can load it up. The Elevator Action is set to Game 2, so its always booting to the empty slot., but the connector and wiring look different between the 2 slots.
If we cannot ID this connector to put a compatible board in it we will likely re-wire the whole cab to just be 1 game/Elevator Action. We have a few hundred PCBS here though, so very likely i will have something around that will work with it once ID'd.
Anyone recognize this?
If we cannot ID this connector to put a compatible board in it we will likely re-wire the whole cab to just be 1 game/Elevator Action. We have a few hundred PCBS here though, so very likely i will have something around that will work with it once ID'd.
Anyone recognize this?
