Odd phenomenon here:
I noticed that Metal Slug 3 on slot 1 of my multi prefers less than 4.9v. Just a bit higher and the title screen appears followed by an endless reset loop. Anything slightly above 5.0v results in a blank or green screen. However, Garou MOTW on slot 3 of my multi seems to work just fine at 5.0v and even slightly higher.
In this particular case I’m using an MV1FS mobo, Windy Gaming ATP-300 supergun, and a cheap Performance Tool voltmeter (poking my leads directly in the jamma edge). My DS multi is on firmware rev 0x0431, build 05bfb, and top 0x35bb.
I noticed that Metal Slug 3 on slot 1 of my multi prefers less than 4.9v. Just a bit higher and the title screen appears followed by an endless reset loop. Anything slightly above 5.0v results in a blank or green screen. However, Garou MOTW on slot 3 of my multi seems to work just fine at 5.0v and even slightly higher.
In this particular case I’m using an MV1FS mobo, Windy Gaming ATP-300 supergun, and a cheap Performance Tool voltmeter (poking my leads directly in the jamma edge). My DS multi is on firmware rev 0x0431, build 05bfb, and top 0x35bb.