ok for the heat.
after a 5 hours straight test case is slightly warm to the touch.
it always a bit warmsince its packing a bit of heat in there, but like always aluminum dispatch heat nicely.
Just to be sure maybe ill put holes hidden under the logo (won't be seen) like .100" dia.
TMNT is a pricey pcb and i wanna be sure it breath correctly
ill keep that no holes version for myself...i never plays more then 1-2 hours so its fine.
Everyone ordering one will have that new updated version
Logo plate will also have a minor update since sticker is a bit too large to fit on.
but besides that i think everything is good to go :3
what more to say then....Pre-orders open ?
I'll keep them open until march 15. I need to reach at least a minimum of around 8 cases at least to proceed.
If by march 15 it is not reached i'll have to extend the pre-order time or cancel
i wont ask anyone money until then
so anyone who have contacted me until now ill ask again just to be sure tomorrow...or you can just write it back again starting now
you can order any of my previous cases and i will also try to make a special TMNT gift to go along for THIS order only (unless i end up with extras for next batch)
I still have a few CPS-1 logo aluminum art for the first who order one
(not sure think i still have 3)
thanks and i hope this will be as much fun as the first batch was
if you have any questions ---> ask !