Telpherion
Student
Sure, any vector edition program should work: autocad, Illustrator, Gimp, Corel, etcI should be able to create case models like this using autocad, correct?
Sure, any vector edition program should work: autocad, Illustrator, Gimp, Corel, etcI should be able to create case models like this using autocad, correct?
I expect to do for NBA Jam and Mortal Kombat 2 (same board I think) shortly, because I have both of them.I have had a few of these cases made and I really like them.
I was wondering, though, if anyone had case designs for a few boards that I would like to put in cases:
NBA Jam TE (with sound board)
Gradius III
R-Type II
I expect to do for NBA Jam and Mortal Kombat 2 (same board I think) shortly, because I have both of them.I have had a few of these cases made and I really like them.
I was wondering, though, if anyone had case designs for a few boards that I would like to put in cases:
NBA Jam TE (with sound board)
Gradius III
R-Type II
Thats a short A-board, it has the same footprint as the Dash A-board... Long A-board is the oddball/different.So the entire SFII board (the A board on the bottom of the stack) is 24cm x 30cm (not including the jamma connector)
If I measure the distance from the center of the holes on the edges its 23cm x 29cm
I was thinking in some kind of hang on the boards inside the cabinet, and being able to exchange quickly games with these cases. So inside the cabinet, on one side put 4 clips or something like that, so you can just hang the board there and connect the jamma harness. They are all the same size in all boards and are centered.@Telpherion Just a quick question : what's the purpose of these 4 square holes in every bottom plate ?