I got an taito x4 with magicians dead game, raphnet wii adapter, wii nunchuck, leap motion controller, k92x0331b rfid reader, and a k9101258a usb io board. I am planning on installing in a vewlix. 1st thing I noticed about usb io compared to jvs io in vewlix is the plug for controls is 62pin vs 60 but that an issue I can cross later cause I still can’t get the game to start. I have the usb io powered with 12v on pin 1, 5v on pin 2 and 3&4 both ground just with no controls wired yet since pin size is different. The board lights up when powered and the smoke didn’t come out thankfully so I suspect that may be good. The rfid reader is not currently wired up cause at moment I have no clue how to wire it. With all the above being said when I power up the x4 with all devices attached except for the rfid reader it sees the wii nunchuck and the leap motion controller but the usb io still does not get noticed as well as the rfid obviously. All three devices attached are plugged into a USB port on the x4. Does anyone have one of these or past experience with this and can please share some tips of what I’m missing or maybe share manual or link to it?