Hi all,
Just wanted to share a modest 3D printable cover I made for my Mean Well MWP-606. I use a minigun supergun that I like to operate on my desk out in the open. I power it off of an MWP-606 power supply.
Not wanting to electrocute myself when I wasn't paying attention, I went looking for a terminal cover that I could print. I started using the one designed by @RGB:
3D printed cover for Mean Well MWP-606 [STL inside]
It worked great but then I saw this one that had a power switch on it:
https://www.thingiverse.com/thing:4462296
I REALLY wanted to build this one but wasn't needing all the bells and whistles. So I set out to make my own that I could use with the super common IEC connectors I see on Amazon. So I came up with a much less exciting version that meets my needs:
https://www.thingiverse.com/thing:4594304
It is not exciting but it does what I need it to do. Sharing the STLs in case they are of use to anyone. I am not an expert on this stuff so USE AT YOUR OWN RISK.
Just wanted to share a modest 3D printable cover I made for my Mean Well MWP-606. I use a minigun supergun that I like to operate on my desk out in the open. I power it off of an MWP-606 power supply.
Not wanting to electrocute myself when I wasn't paying attention, I went looking for a terminal cover that I could print. I started using the one designed by @RGB:
3D printed cover for Mean Well MWP-606 [STL inside]
It worked great but then I saw this one that had a power switch on it:
https://www.thingiverse.com/thing:4462296
I REALLY wanted to build this one but wasn't needing all the bells and whistles. So I set out to make my own that I could use with the super common IEC connectors I see on Amazon. So I came up with a much less exciting version that meets my needs:
https://www.thingiverse.com/thing:4594304
It is not exciting but it does what I need it to do. Sharing the STLs in case they are of use to anyone. I am not an expert on this stuff so USE AT YOUR OWN RISK.