AGCRetrogaming
Student
Hi everyone
I'm trying to create one video output board for JAMMA boards with RGB parallel, Component Video, S-Video, Composite Video and Audio.
for this project I'm using both AD725 and the BA7230 at the same time. Basically I used the same circuit provide by the chip maker and I adjust a little bit acc. some recommendation.
But something still wrong because when I tried my supplier power just burned out.
Please see attached the schematic what I'm using, I really do appreciate any suggestion and advice regarding improvements or changes.
Thanks for the support
I'm trying to create one video output board for JAMMA boards with RGB parallel, Component Video, S-Video, Composite Video and Audio.
for this project I'm using both AD725 and the BA7230 at the same time. Basically I used the same circuit provide by the chip maker and I adjust a little bit acc. some recommendation.
But something still wrong because when I tried my supplier power just burned out.
Please see attached the schematic what I'm using, I really do appreciate any suggestion and advice regarding improvements or changes.
Thanks for the support