bradjewell
Beginner
I have a Wells-Gardner 19K4903 that has about an inch of black on the
right side of the screen. I have adjusted the Horizontal shift pot and
in one direction it moves it more away from the right, and when all the
way in the other direction, this is the closest it gets to the edge.
It has been recapped in recent years.
It does not have the wire to go to the horizontal raster position pin.
I have not had any luck adjusting the horizontal width coil.
It currently has a 999 in 1 Pandora's Box 5s Jamma attached, but it the
same screen issue with my Gate of Doom jamma board and my Bad Dudes
jamma board.
Hoping someone on the forums can help me out on this.
Thanks for looking!
right side of the screen. I have adjusted the Horizontal shift pot and
in one direction it moves it more away from the right, and when all the
way in the other direction, this is the closest it gets to the edge.
It has been recapped in recent years.
It does not have the wire to go to the horizontal raster position pin.
I have not had any luck adjusting the horizontal width coil.
It currently has a 999 in 1 Pandora's Box 5s Jamma attached, but it the
same screen issue with my Gate of Doom jamma board and my Bad Dudes
jamma board.
Hoping someone on the forums can help me out on this.
Thanks for looking!