I am currently working on my second fixed arcade gun conversion for use with mame. I picked up an old LA Machine Guns / Gunblade gun but I am a little confused with the wiring and stripped screws are making it difficult to get inside to look...
There are two 3 wire cables which I assume are for the X and Y pots. Then there are two identicle 2 wire cables. I assume one is for the trigger and the other is for the motor but both have red and white wires. When I look through the gap at the motor, I can see red, blue and black wires but no white.
There are also two green ground wires and again, it's not clear what these are for or if they are needed for my Apac wiring?
So, if anyone here owns one of these cabs, please can you confirm that the recoil motor cable has just a red and white wire for a 24v PSU? Also, please can you tell me what the two green wires connect to at each end?
There are two 3 wire cables which I assume are for the X and Y pots. Then there are two identicle 2 wire cables. I assume one is for the trigger and the other is for the motor but both have red and white wires. When I look through the gap at the motor, I can see red, blue and black wires but no white.
There are also two green ground wires and again, it's not clear what these are for or if they are needed for my Apac wiring?
So, if anyone here owns one of these cabs, please can you confirm that the recoil motor cable has just a red and white wire for a 24v PSU? Also, please can you tell me what the two green wires connect to at each end?