SYSTEM 16B C2 & IREM M72 MULTI GAME SELECTORS
- Uses standard Ethernet to connect remote and adapter
- 16 position rotary.
- Reset button.
- 16B uses a SPST latching push button to change between two sets of 16 games.
To connect the reset line, only one wire is needed to be soldered for S16B and two wires for M72/C2.
-M72 reset instructions
-C2 reset instructions
So you want to build your own? OK no problem! Here's what you'll need
-RJ45 Jack (PCB is deigned to work with this specific jack)
-2x4 Pin female Pin Header (M72/C2 only)
-JST XH 2.54 2 Pin right angle kit (M72 only)
-JST XH 2.54 2 Pin straight kit
-Alps SKHCBFA010 Tactile Switch
-Hartmann PT65503 Rotary Dip
-2x5 Pin right angle Pin Header (16B only)
-Flashlight Tactile Switch (16B only)
-Right angle Header Pins (16B only)
-Dupont Jumper Cable for reset line (16B only)
-Adhesive PCB mounts
-2 Conductor Cable for reset line
Reset Cable for M72 should be around 34CM/13.4" and C2 should be 14CM/5.5"
Everything linked is from Aliexpress except for the Rotary Switch and 2x4 Pin headers which are from Tayda. Stay away from the Aliexpress 2x4 Pin Headers as I've found the metal used in them to be hard to solder to, the Tayda headers are of very high quality.
Also check Tayda's Facebook page for a 15% off code as they do them all the time.
Feel free to hit me up with any questions or queries.
The post was edited 72 times, last by oneleaf86 ().