Recent content by BlinG

No it doesn't. The monitor chassis gets 120v from your wall outlet. The PSU is just a passthrough for that voltage.

https://www.digikey.com/en/products/detail/molex/1731120256/9352853 I used these and they work fine for my config. They are not easy to screw in because you have to hit it with an angle but I never plan on removing the decoders. It secures it from getting yanked out and that’s what matters to me.

Selling one of my CPS3 set ups. Comes with the following: CPS3 motherboard with full set of SIMMS Darksoft Cart Red TRFightstick CPS3 case SCSI2SD Volume knob was scratching and causing the audio to cut in/out, so I sprayed it with contact cleaner to resolve it. I dunno if that's a permanent...

Isopropyl 91% and a toothbrush or qtips. Just keep scrubbing it until it slowly breaks down. You might even have to pry it a little to loosen it from the frame.

It looks like the flyback screen pot is set too high and the rgb probably needs adjustments too. Was there something wrong with the flyback that they needed to change it? Hopefully they did not put a Chinese flyback in there, because they’re not very good compared to the original. I’ve never...

I had buyicnow burn this for me and it didn’t work either. I just assumed it was a bad burn

The caps on the daughter board for the high voltage look original. I believe there was a theory that those caps being out of spec can cause the chassis to toast up the tube.

There's usually 3, but I only see two in your pics Yes. Just make sure you put them back the same way they were connected. Otherwise you might get a flipped screen. You can also remove the entire metal chassis frame by removing the screws underneath the monitor frame.

1. Remove the screws that are holding the black plastic frame down to the metal frame. They are on the rear side of the chassis. There are usually 2 screws holding down ground cables, which your last photo confirms 2. Disconnect the red degauss cable from the chassis 3. Disconnect the AC line...

JCL does decent paint jobs from what I have seen. It’s not rattle canned with over spraying

For Sale Head 2 Head Sega Blast City Candy Cabinets with CPS1 I have two Sega Blast Cities available for sale. I have owned these cabinets for a few years now, and they just don't get any play time anymore. Here are the goods and bads for these cabinets. Good: Comes with Street...

I'll take a 20 pack. Thank you!

Honestly with a 2931 chassis, I would just send it to someone who knows how to fix it. It’s a known problematic chassis and very difficult to troubleshoot. If you have never done any CRT monitor work, this is not the chassis to start on imo. It’s the reason why people suggest not getting a...

Might wanna get a rejuvenator to test the green gun to make sure it’s not dying.

We tried using one of those AIO gbs-c units for cps3 capture and it didn’t work out well because it was missing the clock generator mod and some other cap mods. So I would follow up with the seller if it has these. The gbs-c isn’t focused on arcade hardware from the research I’ve done too.