Recent content by faithful

Hi XtraSmiley, thank you. I will try to play with CSync SW2 switch (and as a last resort with the SW3 switch). I noticed the two switches and I read the manual about them but I was afraid to mess with something and damaging my beloved PWM. Thank you again.

Hello, I noticed that some boards (original and bootlegs) displays and image problem with the HAS that is not present If I connect directly on an arcade cabinet. The image is distorted diagonally and the "NO SYNC" text is displayed on my PVM (SONY 20M2MD). In most cases also the sound is...

Hi Derickk2k, do you have some instructions and components to buy to replace the DC-DC converter to one that is capable to appropriately power the NAOMI 2? Thanks in advance.

Thanks.

What are the differences between 4.0 and 4.1?

Maybe I can contact him directly via PM to check if there are some circuit left to sell or if he can open-source the design (If he’s not interested to sell them anymore).

Could you give me some indications where to find this boards? I searched the entire document and nothing seems to fit... :(

The problem with an upscaler is that the output is digital only. I cannot connect it to my PVM... :(

I don’t know... For sure is very impractical because a 20” crt is bulky and very heavy. As an alternative I could design a circuit that swap the yoke connector via a switch outside of the chassis.

I have a Sony PVM 20M2MD. The monitor isn’t dedicated to this particular board. It’s connected to a HAS where I connect all my boards. If I swap the yoke connector I need to open the PVM every time I want to use any other PCB... not very practical... I don’t have another monitor (and space) to...

Hello everybody! I found a bootleg pcb of New Zeland Story (the original is priced too high for my pockets) and I am happy as ever! :D But ... the image is upside down an from what I read I cannot do anything about it.. X/ (aside to rotate my heavy crt of 180°!) So: there is any analog...

Anybody tried this cable? Usually their products are good at least.

Hello, I’ve seen here and there someone that sells ST-V cartridges conversions. There is a guide or a tutorial about it? I haven’t found any in this forum. Thanks in advance.

Ok, put it in this way: I need to have the bare minimum b board to use it for the dark soft. The less I pay it the more I will be happy.

Hello I'm searching for a Suicided Euro/USA/Japan CPS2 B board to use with the Darksoft kit. Please help me.