Recent content by GGPO_Halfro

Shipping possible? (vewlix cabs)

I tried a couple off the decrypted files I found (SFA2, Marvel Super Heroes and AVP), no response from the video feed there either. Ill keep working at this.

Definitely! I will work on that today and post results here. Thanks so much for the ideas and help on this.

- I touched all 3 pins simultaneously on EXC5 with no change - Tried booting a different game, no change I looked over the pins on the A + B boards just to make sure there arent any broken / bent pins and I didnt notice anything. I took it all apart and cleaned everything, still no result. :(

Alright working some more on the project this morning: I did some research, I picked up my board in 2019 from paradise arcade shop. I am assuming the firmware should be the correct one to play the games as long as the key write wires are hooked up correctly (which I believe I did after your...

EXC5 CAP? LOL well lets work on this some more stuff to work on. So I need to short the EXC5 Cap....all 3 legs or? I soldered the key writing set up to C9 from the darksoft.

I will give the test data a shot just to check it actually is working as intended. I do not have the key writing wires soldered, if that is a requirement, I must have missed it. I will also research that info.

Alright, for the time being I had some roms already on the card, it appears based on the "OK HAVE FUN" message that the roms are being loaded correctly but.....

I have attached my CPS2 AV photos above, here is the Darksoft set up. As I post I am noticing how dusty it really is, I am going to disassemble, give a good scrubbing and then reassemble.

I have a cps2 with a few components that I am using together. Things have been going good-ish thus far getting it together (from what I can tell), however when I have just finished wiring up my CPS2 HDMI AV board, all I am getting a black screen (with response from the buttons including...

lol Fair but doesnt hurt to ask no?

For the pair? Shipping to 34677?

I have been putting off finishing mine for so long, if you had some time, I had a couple questions about the power portion wiring.

No problem! Honestly I would like to create a resource since I am still working on mine and it would be a good way to document the process to catch it from this point. I need to do the power supply next so I am going to do some research and then post the process + pictures. It doesnt seem that...

So I have been working on this (in my spare time, work / school / kids lol), I did a little research because I wanted to do the project justice and I did not want to alter the original function of the board (keeping jamma edge etc). My project is: Phoenixed Street Fighter Alpha 1 board Darksoft...