Recent content by Loonz605

When I received my cabinet it was setup with gdrom, gamedisk and original pic. It had issues with the gdrom. I will look into the ip reassignment some more and see what I can come up with. Hopefully find a way to configure the pi so it can stay connected if the game ip changes after boot up. Thanks

Yes, it still does seem to time out in a couple of minutes if I leave it on that screen with the error code 33. You had previously mentioned it could be a power related issue. Is there anywhere I can check voltages or any write ups you know of on how to do so. So I could see if thats a possible...

It is close to the same time probably 2-3 minutes into the game. I'm able to coin up but it still doesnt acknowledge when I press the gas. Outrun I tried last night and a game message comes up about a jvs I/o board issue.

I get no reading from the lithium ion battery pack. The 2032 battery was right at 3v. Fan comes on no problem. Gas, brake and steering all seem to be working when I do the test. And yes the time set limit is what I removed the values from. I also noticed what you had mentioned about the zero pic...

Jumper settings

When you try without a pic installed it shows an error code for media board malfunctioning. And the same after the pi sends the game. I was able to edit some text in the piforce tools file for the Triforce section and removed the time to disconnect. Now the game stays on long enough to show...

Thanks for the reply. I’m guessing to check the file I just open in notepad? Which I did. It starts with fatx but no numbers just followed by symbols. I’ve messed with it a little more today and the link is set to off in the game menu but still says searching for pcb 2.3 and 4, which it stays on...

Hi. I’m new to the forum and arcade scene but I’ve been doing a lot of research on the site so figured this is where I would first seek help. I have a maximum tune 2 cabinet with a type 3 Chihiro that I’m having a hard time getting to NetBoot. I’m using a raspberry pi with pi force tools v1.5...