Recent content by seanr28

As above please, obviously fully working.

i may have just sorted it, removed the board and checked again the jumpers under them and both of the OPEN ones, were actually joined! I missed it completely. Will test again shortly......and report back

what do you mean no wire??? Its a rev 7 using a Pal G chip... will get a picture of 2nd set of jumpers

I have also just pulled a working PAL G chip from another cart, but that dont work either

here you go

As above, its a revision 7 board, all jumpers are definatley correct, I have also used a meter to confirm this. The only thing thats im unsure of it is the PAL chip, It was ordered as a "PAL-G" from your European Distributor, with the CPS2 multi kit but its reads GAL16V8D 15LP Is this...

yes its deffo the b board at fault, been tested on 2 different A boards and they both work with other games.

here you go, Yes its been cleaned, no bent pins. all socketed chips have been removed, checked and re-seated.

thanks, but I have far to many boards to fix before taking on anymore:) any other suggestions please?

I do agree, I've been trying to get a dead or phoenixed board for a while.......I'll get this one working first though mind you.:) ......if I can that is... what is that very top board for?? seems to work without it???

yes is a legit version, would prefer to sort it and use another game if Im honest with you.

no, makes no difference...

all roms removed and re-seated, b board plugged directly into A board without case....nothing appears to make any difference..

no bent pins and have re-seated 4 times already.:(