Recent content by ShllShockArcade

Yeah it doesn’t matter the Molex connector you choose a long as they are connected up appropriately 👍🏼 RGBGnd and Sync

Worked perfectly and was really simple to solder. Please forgive the sync line … I ran out of the Molex connectors so I just did a simple .062 crimp connection to get it to work at the time 😊

I did

Interested in Lethal Enforcers depending on shipping cost to US. PM’ed 👍🏼

I gotcha, got to work with what you’ve got 👍🏼

Y yes you are correct that is the entire intention behind the JINX adapter board (changing out the location of the start and attack button). I really want to try the 2.3J rev now 🤩🙌🏼

A 10 ohm resistor is a lot different than a 1k ohm resistor also …. Who soldered this resistor back in for you? And why didn’t they test the bird after their work was complete? Very Odd 🤔 glad it works again though 🤙🏼

Going to have to look into this 2.3J Rev! That sounds awesome! Thanks for the heads up! 👍🏼

If it’s missing a 1k - 1/8 watt resistor I would purchase a set of these and replace accordingly. I’m a guessing this isn’t your problem though but you never know 🤷🏻‍♂️

Interesting thing is the document you show has a 1k ohm resistor but the picture of yours shows a 10 ohm resistor … I can’t make out what the other board has in its place, it’s too blurry.

About the multimeter. Ok then the safest approach would be for you to back the power supply all the way down while powered off and then power it on and slowly increment it up while monitoring the +5V line until you hit between 5 and 5.10 volts. Then take a look at your -5 and +12V and make sure...

Where on the board is R152 located? Any of us could take a look to see if it exists or not 👍🏼

Start by testing your new power supply under load. Do you have a crummy board that you can test with? Plug the power supply in and read the +5, -5 and +12 volts.

I totally forgot you were even making these!!!! Now that’s an added bonus for sure! Thank you! 🙏🏼🤙🏼

Looks great by the way 🤙🏼