Recent content by skeletalpeacock

I wanted to report that I just resolved a case where my adpater and jumpers seemed perfect by swapping out my naomi 2 unit. The naomi would send out ACK 5 times, then go no further and fail. The expected behavior is roughly - Card reader sends ACK (0x06) NAOMI sends ENQ (0x05) Card reader...

i’m down for one!

Hi, I would be more than happy to buy this from you for 300$ if you still have it. Cheers.

sure. put me down for one

interesting. i was able to order one now. i’m not sure why it was marked unavailable a few hours ago, but im not complaining! let’s go!

rip, missed the boat i guess

works for me on shipping together

2 units please

if dirt fox is a suitable baseboard set for this multi, then please put me down for a pre order!

Uh… change Q406…

Hey all, just wanted to say thanks. This worked first try without a hitch. I did have trouble finding the konami region codes so here they are for the next person - Jaa = Japanese region version a Aaa = Asian region version a Uaa = U.S. region version a Eaa = Europe region version a Jab/jba =...

Ah, so it is that circular region! I opted to go through the wall, as you did. It was too hard to solder into that little ridge area, and the dremel didn’t expose more. Thanks for clarifying!

Hi all. Thanks for the advice on this fix. I'm attempting it myself but I'm stuck. I cant find any evidence of where the positive tab went. I have the battery fully out. Can I please get a clarification of what "underneath is the + tab" means? Do I need to dremel under where the battery was to...

Hi, I fixed this issue by replacing Q406, which I think is the HOT. Part number 2SD2012. Got two right from eBay for 4$ plus shipping. Beat of luck on your set!

Hi, I just wanted to let you know that I have the exact same problem. That being, I recapped this chassis, but still have bad pin cushion issues. I found the schematics and so on, but frankly I don't know enough about what I'm doing to identify where the pin cushion circuit might be in order...