Recent content by theangel540

Vidéo with break ball Vidéo with "forced" break ball :cat:

Found the culprit! 4MB flash (x2 modules) for Prog menu good. 32MB flash (x4 modules) for Tiles/Cha menu good. Work/decrunching ddr2 module > FAIL The one below the Cyclone. And honestly, the owner not being gentle (not my multi), the inevitability of BGAs comes back at a gallop. Dead...

OK. I have a proper clock signal for the FPGA. I'll check the buffers tomorrow. Have you made all the job for menu/interface (tiles, titles) and 68K code ?

Thank for your precious help! 'will see the octal buffers. Just curious about the utility of the Cyclone ? (Pre decrunching encrypted ROM to ram section before soft reseting or decrunching in real time ?) Amazing job, pcb, really!

Hello! I'm fighting again a Multi AES wich no boot :sorry: the symptoms are: - White screen with no SD (normal). - With SD card: Black screen with little shade of grey in the upper portion of screen (seem to be the backround of the menu but totally empty, only the black backscreen with grey...

Thank so much!

Hum, the No MCU 68K romset is lost on the web ! ;( My original moonwalker have the "no dance bug" with old decrypted romset (after a suicide FD). Is there a way to found the great romset of Apoc (moonwalker no mcu) ? thk a lot!

Hello! Need a NEO-C1 QFP for repairing my MV4FS. No OE\ signal on SP1 OTP ;-) Thank so much.

Hello! If anybody have a dead F1 grand prix / tail to nose / super volley ball ... I need a VS8904 QFP. Mine is dead with broken legs :-(

Hello! Does anyone have this manual? there is really nowhere to found it :-/ The hardware looks a lot like city connection. I suspect a binary counter LS161 for sprite issues. Very hard without schematic :-( A big thank-you.

I need to repair a classic euro league PCB. This is the Bootleg version of world cup 90 from TECMO. I have on GAL dead (the one who drive the sprites layer). The MAME dumps are wrong :-( (wc90b1, wc90b2, wc90ba. Anybody for dumping the GAL16V8 near the x8 512Mbits eproms column. Thank so much!

OK, thank.

Do they have a regular SH2 soldered ? Thank!

I have some TOP3000/TOP3100 dead :-( These units are equiped with a STM32F103 onboard MCU. Has anyone tried to recover the firmware of these programmers ? I know STM32 binary are locked and it's almost impossible to dump one, but there would be a way to read them. So sad to have so much units...