Recent content by wahlalla

Hi, I need to replace two damaged 63S241N (the ones highlighted in red in the photo...) on the small board in the photo. This little board with the TMS32010NL chip in the center is found on a bootleg arcade PCB from Wardner...

Hi everyone, I should replace these Tmm2115BP - 10 rams on my Super Hang On PCB..(now difficult to find..)....which rams could i replace them with? on sale (ebay - Aliexpress) I found Tmm2015BP - 10, Tmm2015BP - 90 or Tmm2115BP - 15..which of these could be good or could you recommend other...

Thanks again..:)

Hi everyone, I have to replace the 5k potentiometer on the handlebar of the Super Hang On... (it's old and I also found two pins unsoldered...)... the connector has three yellow, red and blue cables in which order they should be soldered on the new potentiometer shown in the photo? (from left to...

Thanks for your help friend...:):)

Thank you for your help...in fact I'm noticing that in the electrical diagram the pins are indicated not in sequential order therefore: 1,5,4,6,2,3...So following this diagram the wiring of my molex should be correct right? :)

Hi, I'm restoring my Arcade Cabinet Super Hang On and I need clarification... I'm reconnecting the SSR board for the vibration and I noticed that the 6 pin connector is wired differently from what is indicated in the manual..... looking at my photo from left to right we have pin 1 empty, pin 2...

Hi everyone, I need a monitor mask for the Arcade Super Hang On cabinet..does anyone have one? Thank you

Thanks

Hello everyone, I found a Super Hang On upright model arcade cabinet and I would like to restore it......I saw that the turbo button is disconnected (the cables are cut)... I would like to reconnect it to the PCB... where should it be reconnected? Thank you

Hello, Is it possible to set Atomiswave games with single boot? Thanks

it's the same file I used ... I checked now but it doesn't work .... could it be the Naomi 2 multibios?

Hello, I have a problem with Metal Slug 6. I load the game from CF on a Naomi 2 multibios with netdimm but the game does not start ... (it seems that the game is not recognized by the netdimm ...) .. I only have problems with this Atomiswave game .... what can it depend on? Thanks

Hi, it's possible to have a backup of dongle ver. D? Thanks

Thanks Matt..when you can .. :)