Recent content by XianXi

  1. XianXi

    MK30 ADCAP Supergun BROKEN, Help Requested Please

    Check the pins in the harness that contact the board, sometimes over the many insertions the pins get bent and don't make as good contact as before, you can try bending it back to match the others.
  2. XianXi

    JNX Lazy Finger - Inline DB15 Rapid Fire Adapter

    Ah, you use it in your cab? You didn't want a Spitfire instead?
  3. XianXi

    Hypernoid - Neo Geo Homebrew Release

    There needs to be more variety on the Neo I feel, I welcome it.
  4. XianXi

    JNX Lazy Finger - Inline DB15 Rapid Fire Adapter

    Lions3 has them.
  5. XianXi

    JNX Namco System 11/12 Kick Harness Adapter

    Got them up on ebay. https://www.ebay.com/sch/snk-guru/m.html?item=154514986808&rt=nc&_trksid=p2047675.l2562
  6. XianXi

    JNX Spitfire - JAMMA Rapid Fire Inline Adapter

    Yes, PM please
  7. XianXi

    MK30 ADCAP Supergun BROKEN, Help Requested Please

    I never said it was. It was something that wasn't done, might as well do it while it's open.
  8. XianXi

    Namco 359/369

    A friend of mine has this, how do you get the kicks to work?
  9. XianXi

    Pulstar and Ironclad conversions help

    No problem dude, I've made over 200 Ironclad carts back in the day, I went through the same stuff.
  10. XianXi

    Pulstar and Ironclad conversions help

    27C322s are 16bit only while V roms run only in 8bit mode. Also Vroms when split are sequential meaning V1 when split becomes V1 and V2, not like C roms where when split alternate.
  11. XianXi

    MK30 ADCAP Supergun BROKEN, Help Requested Please

    It gets rid of the interference/noise on screen.
  12. XianXi

    MK30 ADCAP Supergun BROKEN, Help Requested Please

    Usually by tying logic ground to field ground aka earth but I think you said this is only a 2 prong system so I’m not sure.
  13. XianXi

    MK30 ADCAP Supergun BROKEN, Help Requested Please

    Yes, if the inside is 4A, make the outside 3.5A. There are fuses of all sizes for each rating, just grab the length you need, no need to change the holder.
  14. XianXi

    Help with Top3000 Programmer Drivers

    Just swap the pins. That’s what I did on mine. I soldered leads to the solder points of the socket for those 2 pins that are swapped and then just lift the 2 pins on the eprom and clip on the leads then program.
  15. XianXi

    MK30 ADCAP Supergun BROKEN, Help Requested Please

    What I meant was the outside fuse should be 0.5A smaller than the inside fuse. The outside fuse should blow before the inside one. If the inside fuse keeps blowing before the outside one then the outside fuse is redundant.
Top