Recent content by xwred5

My High Score Saves extension cable was crimped this way. Was a little tight, but worked.

Re: key writing: You can buy connectors and pre-crimped wires. connector: https://www.digikey.com/en/products/detail/jst-sales-america-inc/H6P-SHF-AA/1885755?s=N4IgTCBcDaICwFYEFo4EYCcBmZA5AIiALoC%2BQA 4" long leads...

This is my first Darksoft purchase (Thank you). I plan on installing Friday.... Anyone looking for the key writing cable, I picked these up from digikey. I have a 93646BG-3 board, so I will have to cut off the second end and extend. There are various jumper lengths...

Frank, no apologies needed. your work has been awesome, it's an easy fix for existing boards that are programmed and an easy fix to implement. I made an account on this forum just to thank you for making your designs available. Also thanks to RGB and Arthrimus!

This worked! I cut the trace near the SNES connector, was pretty easy to access if anyone else has this issue. Torn on adding the external resistor. It looks like this pin is used for programming, maybe consider adding a solder strap, I liked the programming board a lot, I am not sure I would...

I found some 10k resistors. Will attempt this surgery "ASAP".... which might be tonight or this weekend. Getting the SNES port out is going to be a PITA, the holes could be a little wider on the next revision to fit these (measured like #17 AWG, ~1.15mm).

A potential Bug/issue System Neo Geo AES Unibios 4.0 When I am in MVS mode via the Unibios, the controller doesn't work. I can't program buttons. This is true for both the NeoSD and Sam Showdown 2. I have a pathetic library. in AES mode, it is fine. Regardless of BIOS settings, the NeoSD...

Thanks for making these available. I built up a handful of them this afternoon.